LTE-CellScanner

Mobile (4G / LTE)Ready to RunLocation: /opt/telcosec/lte-cellscanner/

Command Line Execution

Run this command in the TelcoChisel terminal to launch or execute the tool:

LTE-CellScanner Command
LTE-CellSearch -s 2650e6

Detailed Technical Overview

LTE-CellScanner is a pre-installed tool in TelcoChisel OS. Open-source LTE cell searcher and MIB/SIB decoder. Scans a frequency range and decodes cell IDs, bandwidth, and system information blocks. It belongs to the '4G' category, supporting advanced security auditing and network pentesting workflows.

Configuration & Usage Guide

To initialize and configure LTE-CellScanner for telecom security audits, follow these steps:

  1. 1Configure EARFCN carrier frequency and RF front-end gain in the config file.
  2. 2Ensure low-latency kernel privileges: id | grep realtime
  3. 3Launch LTE tool: LTE-CellSearch -s 2650e6

Troubleshooting & Security Audits

LTE-CellScanner Audit Warning
Reduce RF bandwidth (e.g. from 20 MHz to 5 MHz) if USB 3.0 controllers drop samples. Avoid running 4G high-rate PHY layers inside virtual machines without passthrough.
LTE / 4G LAB

Master LTE-CellScanner with Interactive Telecom Labs

Practice deploying LTE-CellScanner against live cellular networks, radio interfaces, and mobile cores in TelcoSec Academy's browser-accessible cloud sandboxes.

Interactive Cloud Labs No Hardware Required CTSP Certification
Launch Interactive Labapp.telcosec.net · Instant access

Frequently Asked Questions

How do I run LTE-CellScanner in TelcoChisel?

You can execute it directly from the terminal or using the command: LTE-CellSearch -s 2650e6

What is the default installation path?

The tool or environment is configured at: /opt/telcosec/lte-cellscanner/

Back to Tools Directory