SCAT

Mobile (4G / LTE)Ready to RunLocation: System-wide (pip: scat)

Command Line Execution

Run this command in the TelcoChisel terminal to launch or execute the tool:

SCAT Command
scat -t qc -d /dev/ttyUSB0 -o capture.pcap

Detailed Technical Overview

SCAT is a pre-installed tool in TelcoChisel OS. DIAG protocol parser for Qualcomm and Samsung modems. Decodes OTA messages from USB-connected phones to PCAP with full NAS/RRC content. It belongs to the '4G' category, supporting advanced security auditing and network pentesting workflows.

Configuration & Usage Guide

To initialize and configure SCAT for telecom security audits, follow these steps:

  1. 1Configure EARFCN carrier frequency and RF front-end gain in the config file.
  2. 2Ensure low-latency kernel privileges: id | grep realtime
  3. 3Launch LTE tool: scat -t qc -d /dev/ttyUSB0 -o capture.pcap

Troubleshooting & Security Audits

SCAT Audit Warning
Reduce RF bandwidth (e.g. from 20 MHz to 5 MHz) if USB 3.0 controllers drop samples. Avoid running 4G high-rate PHY layers inside virtual machines without passthrough.
LTE / 4G LAB

Master SCAT with Interactive Telecom Labs

Practice deploying SCAT against live cellular networks, radio interfaces, and mobile cores in TelcoSec Academy's browser-accessible cloud sandboxes.

Interactive Cloud Labs No Hardware Required CTSP Certification
Launch Interactive Labapp.telcosec.net · Instant access

Frequently Asked Questions

How do I run SCAT in TelcoChisel?

You can execute it directly from the terminal or using the command: scat -t qc -d /dev/ttyUSB0 -o capture.pcap

What is the default installation path?

The tool or environment is configured at: System-wide (pip: scat)

Back to Tools Directory